How to Using the electronic cigarette

The electronic cigarette is a device that has evolved considerably in recent years, currently on the market one type of cigarette much more effective for smoking cessation which is composed of three parts: a battery with manual switch, claromizador and a nozzle with cap. Below we will explain in detail the steps required to use the electronic cigarette .

Instructions

• The first step in using the electronic cigarette is charging the battery:

1. Desenroca battery electronic cigarette claromizador, turning gently in the opposite direction of clockwise.
2. Leave aside the claromizador and nozzle for later.
3. Screw the battery, turning clockwise clock in the USB charger that came with the kit.
4. Connect the charger to the wall socket charger.
5. Connect the wall plug to the grid. At the start of loading the contact button battery blue LED will flash a few seconds. The LED indicator USB charger appears red while charging, and turns green when charging is complete.
6. Once fully charged again tighten the battery claromizador .
7. To lock press the contact button battery 5 times quickly and continuously (for 10 seconds), flashing blue LED indicates that the battery goes idle at that time.
8. To switch back and unlock, press the contact button battery 5 times quickly and continuously (for 10 seconds). The flashing blue LED will indicate that the battery is ready for operation.

• The next step to properly use the electronic cigarette is put in charge of liquid Claromizador , the steps are:

1. Claromizador unscrews the battery. And Keep it upright on a flat surface.
2. Unscrewing the nozzle upper claromizador to open.
3. Choose the e-liquid to fill and remove the safety cap pressing and turning at the same time. Tilt the claromizador slightly at an angle of 45 degrees while slowly pour the liquid directly on the inner walls of the bottle dropper of liquid. Stuffed the desired amount of liquid to a maximum of 1.6ml.
4. Screw the nozzle back in claromizador to close.
5. Let stand a few minutes upright.
6. Very important that you read the articles there at the end of articles on aspects on how to use the claromizador.

• After preparing the electronic cigarette with claromizador and load can already start using it . Here are step by step how to use them:

1. After charging the battery and the claromizador filled with liquid, screw the battery and the nozzle to claromizador.
2. Remove the plastic cap from the nozzle.
3. Unlock the battery. Pressing the button battery contact, you should note that the blue LED lights of this and driven atomizer is heard.
4. While holding down the button battery contact, mouth slowly inhaled the steam produced in the claromizador.
5. Release the button battery contact, enjoy the flavor of the vapor in your mouth and slowly expel it through the mouth or nose.
6. Repeat the operation after a few minutes, remember not breathing hard or fast.
7. To this action is called vaping.
8. It is important that inhalation is not too frequent and that aspiration is not excessive, it is recommended to rest the device a few minutes between inhalation and inhalation. The claromizadores are consumables and as such are not covered by warranty. The USB and wall plug chargers have 2 years warranty . Batteries have 6 months warranty.

To read more articles like using the electronic cigarette , we recommend you enter our category of How to.

Advice

1. Be careful not to spill liquid into the central part of the tube claromizador.
2. No liquid exceeds 1.6 ml mark the upper limit or cap white.
3. Avoid splashing and wash surfaces in contact with soap and water, avoiding contact of liquid with skin and mucous membranes.
4. Fill in claromizador when the load is less than 0.6ml, when steam gradually fade, or when you want to change the flavor. A charge of 1.6 ml equivalent to 800 vapeos.
5. Cleaning and reusing claromizadores is not recommended.
6. Change notes claromizador when it loses power in the vaping, if you notice a strange taste or if you notice any leakage of liquid in the bottom. Each claromizador has a lifespan of about 10 loads, representing 1-2 weeks of vaping. Advised claromizadores extras as needed. For hygiene always keep claromizador nozzle with plastic cap position. Always keep the claromizador tightly closed by the nozzle upright.
7. When the button battery contact is released, the device stops working and no steam. It is recommended not to operate the device without liquid in the claromizador.